Projects > Landscape Walls >

Solana Beach

The owner of the above home at 1128 Solana Beach, California asked if we could build an entry that would look like the one above.

Creating a radius arch, note skill saw. Cut one side of panel with skill saw using diamond edge masonry blade. This radius was cut about every 12" on center. Do not cut through both sides.

Form plywood template to opening size, plum and install.

Install foam panel around template. Drill holes through template, push wires through holes in plywood and fasten to wire mesh and tighten until you have desired shape. Leave the template in place until you have applied a thin coat of cement on the exterior side then remove and coat interior inside with cement or shotcrete.

A side view of radius arched opening. Please note there isn't any footing on the small area of wall shown. Post holes were drilled and # 5 rebar installed which is brought up into the panel's this wall is approximately 5 ft. high and will be 7 in. thick when completed!

The cement has been applied to the top of the radius arch and plywood form removed. Now the cement and or shotcrete may be applied to arch and wall.

< Previous Project Acacia Landscape Services Columns with Custom Foam Shapes & Styles Next Project >